Samsung DVD-HD870 User Manual (user Manual) (ver.1.0) (English) - Page 12

Chapter 2 CONNECTIONS Choosing a Connection The following shows examples of connections commonly used to connect the DVD player with a TV and other components. Before Connecting the DVD Player - Always turn off the DVD player, TV, and other components before you connect or disconnect any cables. - Refer to the user's manual of the additional components (such as a TV) you are connecting for more information on those particular components. Connection to a TV (Video) 1 Using Video/Audio cables, connect the VIDEO (yellow)/AUDIO (red and white) OUT terminals on the rear of the DVD player to the VIDEO (yellow)/AUDIO (red and white) IN terminals of your TV. 2 Turn on the DVD player and TV. 3 Set the Video Output to I-SCAN in the Display Setup menu. (See pages 52 to 54). You can also use the VIDEO SEL. button to change the Video Output mode. (See page 12) 4 Press the input selector on your TV remote control until the Video signal from the DVD player appears on the TV screen. RED RED WHITE YELLOW Audio Cable Video Cable WHITE YELLOW Note - Noise may be generated if the audio cable placed too close to the power cable. - If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 18 to 19) - The number and position of terminals may vary depending on your TV set. Please refer to the user's manual of your TV. - If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD player. - If you press the VIDEO SEL. button when DVD Player is in stop mode or no disc is inserted, the Video Output mode changes in the following sequence: (S-Video ➝ I-SCAN ➝ P-SCAN). When HDMI is connected, these output modes will not appear. - If you set the HDMI output resolution to 720p or 1080i, the S-Video output will not output video. ENG-12