Samsung HPN4239 User Manual (user Manual) (ver.1.0) (English) - Page 17
Memorizing the Channels
View all Samsung HPN4239 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Memorizing the Channels Your PDP can memorize and store all of the available channels for both "off-air" (antenna) and cable channels. After the available channels are memorized, use the CH and CH buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual). Selecting the Video Signal-source Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the PDP (i.e., an antenna or a cable system). 1 Press the MENU button. Press the ▲ or ▼ button to select "Channel", then press the ENTER button. Channel Air / CATV : Auto Program Add / Delete Fine Tune LNA : Ch.Scan Air On √ √ 2 Press the ENTER button to select "Air/CATV". Move Enter Return Air / CATV : Auto Program Add / Delete Fine Tune LNA : Ch.Scan Channel Air STD HRC IRC On 3 Press the ▲ or ▼ button to select "Air", "STD", "HRC" or "IRC". • If you are connected to an antenna, leave "Air" displayed. If you connected cable, press the ▲ or ▼ button to the display the type of cable system: "STD", "HRC" or "IRC". (If you are not sure which type of cable system you have, contact your cable company). 4 Press the MENU button to exit. Move Enter Return Air / CATV : Auto Program Add / Delete Fine Tune LNA : Ch.Scan Channel Air STD HRC IRC On Move Enter Return Note • STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected. Proceed to "Storing Channels in Memory" (Next page). 32 Storing Channels in Memory (Automatic Method) 1 First, select the correct signal source (Air, STD, HRC and IRC). See steps on previous page. Press the MENU button. Press the ▲ or ▼ button to select "Channel", then press the ENTER button. 2 Press the ▲ or ▼ button to select "Auto Program", then press the ENTER button. ➤ Quick way to access the Automatic Channel Setting: Just press the "AUTO PROG." button on the remote control. 3 The PDP will begin memorizing all of the available channels. After all the available channels are stored, the Auto program menu reappears. Press the MENU button to stop. Channel Air / CATV : Auto Program Add / Delete Fine Tune LNA : Ch.Scan Air On √ √ Move Enter Return Channel Air / CATV : Auto Program Add / Delete Fine Tune LNA : Ch.Scan Air On √ √ Move Enter Return Auto Program Air 28 Return Note • The PDP automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes. 33