Samsung HT-AS610 Quick Guide (easy Manual) (ver.1.0) (English) - Page 25

Before Calling for Service Symptom Check Remedy Can't turn it on. • Isthepowercodepluggedintotheoutlet? • Connect the power plug to the outlet. It does not work when the • Is there static electricity in the air? button is pressed. • Disconnect the power plug and connect it again. Sound is not produced. • Are the speakers and external components connected properly? • Is the Mute function on? • Is the volume set to minimum? • Is the speaker setup set incorrectly to NONE? • Properly connect them. • Press Mute button to cancel the function. • Adjust the volume. • Refer to pages 22~23 to select LARGE, SMALL or YES. Picture does not appear when • Is the external component connected the function is selected. properly? Remote controller does not work. • Are the batteries drained? • Is the distance between remote control and main unit proper? The sound from each device is changed during stereo playback. • Are the left/right speaker or left/right input/output cables connected properly? • Properly connect it. • Replace with new batteries. • Operate at close distance. • Check the left/right channel and properly connect it. Can't receive radio broadcasts. • Is AM or FM antenna connected properly? • Properly connect the antenna. • If the input strength of antenna connector is weak, install the FM antenna in a place with good reception. There is no sound from surround speakers. • Is the surround speaker connected properly? • Is S.SPK (Surround) incorrectly set to NONE in Speaker Setup? • Is Surround Mode selected to Stereo? • Refer to pages 12~13 to connect it properly. • Refer to pages 22~23 to select LARGE or SMALL. • Refer to pages 32~39 to select other Surround Mode. There is no sound from center speaker • Isthecenterspeakerconnectedproperly? • IsC.SPK(Center)incorrectlysetto NONE in Speaker Setup? • IstheSurroundModeselectedtoStereo? • Refer to pages 12~13 to connect it properly. • Refer to pages 22~23 to select LARGE or SMALL. • Refer to pages 33~39to select other Surround Modes. 48 Symptom Check Remedy Can't select Dolby Pro Logic ll Mode. There is no sound when playing a DTS encoded DVD. • Is the input signal selected properly? • Select 2 channel Dolby Digital, PCM, and Analog input signal. • Is Digital input selected? • Check whether digital external component is properly connected and refer to page 26 to select the digital input. Product Protection Function Heat Protection • The Protection function will come on if the main unit or power transformer overheats. " " will appear in the display . This function will come on: - If speaker terminal is shorted - If speaker cable is shorted If there is no problem when you turn the unit on again after turning it off, "PROTECTION" will disappear from the display and the unit will work properly. • If PROTECTION appears on the display, check whether the speaker terminal is shorted and then turn on the unit 49 MISCELLANENOUS