Samsung NA30N7755TG/AA Installation Guide - Page 20
Step 7. Check the ignition of cooktop burners, Step 8. Checking the flame quality., CAUTION
View all Samsung NA30N7755TG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation instructions Step 7. Check the ignition of cooktop burners Check the operation of all cooktop burners after the cooktop has been installed and assembled, gas supply lines have been carefully checked for leaks, and electrical power cord has been plugged in. To turn on a cooktop burner 1. Push in and turn the control knob for that 2 cooktop burner to the Lite position. The "clicking" sound indicates the electronic ignition system is operating properly. The 1 burner will light in about 4 seconds, after the air has been purged from the supply line . 2. After the burner lights, turn the control knob to the desired setting. The "clicking" sound will stop and the flame height will change from Max. to Min. during turning the control knob. 3. Repeat steps 1 and 2 to check the operation of each cooktop burner in succession. NOTE • If the burner does not light within 4 seconds, turn the knob off and wait one minute before trying again. • When you push in and turn the control knob, all spark igniters will make a series of sparks, but only the burner turned to Lite will light. Step 8. Checking the flame quality. All combustion flames need to be visually checked to determine their flame quality. CAUTION If you attempt to measure the flame, please use caution. Burns could result. 1. Soft blue flames-Normal for natural gas 1 operation. 2. Yellow tips on outer cones-Normal for LP gas operation. 3. Yellow flames-Abnormal for any gas 2 operation; call for service. NOTE 3 If burner flame looks like 3, the cooktop should not be used until it is serviced. Call for service. Normal burner flames shall look like 1 or 2, depending on the gas type you use. Installation instructions 20 English Install_NA30N6555TG_DG68-01091A-02_EN+MES+CFR.indb 20 10/24/2018 4:29:24 PM