Samsung NA36N7755TG/AA Installation Guide - Page 24
Converting the pressure regulator, Screwdrivers: Phillips
View all Samsung NA36N7755TG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Installation instructions Required tools Adjustable wrench 1/2" open-end wrench Screwdrivers: Phillips Converting the pressure regulator NOTE If you are using LP gas to fuel the cooktop, the following steps and conversions must be made before the flames can be adjusted. 1. Using your fingers, turn the cap. And carefully look at the spring retainer to locate the NAT or LP position. LP Cap NAT Gasket Small flat-bladed precision screwdriver Nut drivers: 9/32" or 7 mm To convert your for use with LP gas, perform the following steps and procedures: 1. Disconnect electrical power to the cooktop. Unplug the cooktop power cord, trip the circuit breaker, or remove the fuse from the fuse box. 2. Shut off the gas supply to the cooktop. Close the manual shut-off valve to the cooktop. NAT LP NAT NAT. Position LP NAT Spring Retainer L.P./Propane LP Position Pressure Regulator 2. Turn the spring retainer over by rotating it 90 deg., pull it from the cap, turn the spring retainer over so that LP is showing, insert it back into the cap, and then rotate it 90 deg. Into position. 3. Screw the cap back onto the regulator and tighten. Installation instructions 24 English Install_NA30N6555TG_DG68-01091A-02_EN+MES+CFR.indb 24 10/24/2018 4:29:27 PM