Samsung NA36N7755TG/AA Installation Guide - Page 26
Adjusting low flame setting on cooktop burners, English, Soft blue flames, Yellow tips on outer cones
View all Samsung NA36N7755TG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Installation instructions Adjusting low flame setting on cooktop burners All Cooktop burner flames should be checked at their lowest setting. Use the following steps to check and adjust the cooktop burner settings. NOTES • Low setting adjustments should always be made with two or more burners operating at the same time. • Call for service when you need to adjust the inner flame of the cooktop center burner settings. 1. Turn on two or more cooktop burners and set them between MED and HI. 2. Quickly turn one of the control knobs counterclockwise to the lowest setting. The flame should stay lit. If the flame flutters or goes out, adjust the bypass valve on the control valve for that burner. 3. Pull the control knob for that burner straight off. 4. Using a small flat-bladed screwdriver, adjust the bypass valve screw in the base of the valve stem. Turn the bypass valve screw counter clockwise to increase the flame size. Flat-bladed screwdriver Value Stem Dual valve Inner flame bypass screw Outer flame bypass screw Combustion flame quality 1 2 3 1. Soft blue flames-Normal for natural gas operation. 2. Yellow tips on outer cones-Normal for LP gas operation. 3. Yellow flames-Abnormal for any gas operation. Further adjustment required. Additional low flame check 1. Quickly open and close the cabinet door while the cooktop burner is set on LO. If the flame is extinguished, increase the low flame setting and repeat the test until the flame is stable. 2. Turn the knob from HI to the lowest setting quickly. If the flame goes out at the lowest setting, increase the low flame setting and repeat the test until the flame is stable. WARNING 1. Do not completely remove the valve set screw from the valve stem. The valve set screw is an integral part of the gas valve assembly. Removing the valve set screw will cause gas to leak. 2. After adjusting the valve set screw, inspect the assembly for gas leaks. 5. Replace control knob and recheck the low flame setting. 6. Repeat step 1 thru 5 to check and adjust the low flame settings on the remaining cooktop burners. Installation instructions 26 English Install_NA30N6555TG_DG68-01091A-02_EN+MES+CFR.indb 26 10/24/2018 4:29:29 PM