Samsung NE63A6711SS/AA Installation Guide - Page 5
Step 2. Accessing the power cord connection, Step 3. Installing the power cord
View all Samsung NE63A6711SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Step 2. Accessing the power cord connection Terminal block Loosen and then remove the rear access cover screw with a screwdriver. Remove the rear access cover by pulling it right and then out. The terminal block will then be accessible. Access cover Specified rating of power-supply-cord kit and circuit protection Range rating, watts 120/240 volts 3-wire 120/208 volts 3-wire 8750-16500 7801-12500 Specified rating of powersupply-cord kit and circuit protection, Amps 40 or 50 A Diameter (inches) of range connection opening Power cord Conduit 13⁄8" 11⁄8" This appliance must be supplied with the proper voltage at the proper frequency and must be connected to a dedicated, properly grounded branch circuit protected by a 40 amp or larger circuit breaker. NOTE • For power cord installations, go to Step 3 on page 4. • For conduit installations, go to Step 4 on page 5. Step 3. Installing the power cord Conduit connection plate Power cord For power cord installations, hook the strain relief over the power cord hole (13⁄8") located below the rear of the drawer body. Insert the power cord through the strain relief and tighten the device. • You must install the power cord with a strain relief. • Attach the strain relief to the 13⁄8" opening in the conduit connection plate. CAUTION You must check voltage after connecting power cord. Live 1 - Neutral Live 2 - Neutral Live 1 - Live 2 120 V 120 V 208 V / 240 V Installing a 3-wire power cord Neutral terminal Live 1 White Black Red Ground strap Live 2 WARNING The neutral or ground wire of the power cord must be connected to the neutral terminal located in the center of the terminal block. The power leads must be connected to the lower left and the lower right terminals of the terminal block. 1. Remove the 3 lower terminal screws from the terminal block. 2. Insert the 3 terminal screws through each power cord terminal ring and into the lower terminals of the terminal block. Be certain that the center wire (white/neutral) is connected to the center lower position of the terminal block. 3. Tighten screws securely to the terminal block. DO NOT remove the ground strap connection. 4. Go to Step 5 on page 6 to continue with the installation. Black White Red Install_NE63A6711_DG68-01359A-00_EN+MES.indb 4 4 - English 2021-01-04 7:08:26