Samsung NE63A6711SS/AA Installation Guide - Page 6
Step 4. Installing the conduit
View all Samsung NE63A6711SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installing a 4-wire power cord Ground strap Live 1 Black White Red Neutral terminal WARNING The neutral wire of the supply circuit must be connected to the neutral terminal located in the lower center of the terminal block. The power leads must be connected to the lower left and the lower right terminals of the terminal block. The 4th grounding lead must be connected to the frame of the range with the ground plate and the ground screw. Ground plate Black Ground screw White Live 2 Red Ground wire (Green) 1. Remove the 3 lower terminal screws from the terminal block. Remove the ground screw and ground plate and retain them. 2. Cut and discard the ground strap. Do not discard any screws. 3. Insert the ground screw into the power cord ground wire terminal ring, through the ground plate, and into the frame of the range. 4. Insert the 3 terminal screws (removed earlier) through each power cord terminal ring and into the lower terminals of the terminal block. Be certain that the center wire (white/neutral) is connected to the center lower position of the terminal block. Tighten screws securely to the terminal black. 5. Go to Step 5 on page 6 to continue with the installation. Step 4. Installing the conduit 11⁄8" Remove the conduit connection plate and rotate it as shown below. 13⁄8" The conduit hole (11⁄8") must be used. 13⁄8" 11⁄8" Figure 1 1" 3⁄8" 1" 3⁄8" 31⁄2" 3 wire 31⁄2" 4 wire Knockout surface Conduit connection plate Installing a 3-wire conduit Black White Red Neutral terminal Live1 Black White Red Figure 2 Ring Body Strain relief 1. Prepare the conduit cord as shown in Figure 1. 2. Install the conduit cord as shown in Figure 2. For conduit installations, insert the strain relief (not included) into the conduit hole (11⁄8"). Then thread the conduit cord through the body of the strain relief and fasten the ring. Reinstall the bracket. CAUTION You must check voltage after connecting power cord. Live 1 - Neutral Live 2 - Neutral Live 1 - Live 2 120 V 120 V 208 V / 240 V Ground strap Live 2 Wire tips • Aluminum building wire may be used but it must be rated for the correct amperage and voltage. Connect the wires as described below. • The wire you use, the location and enclosure of splices, etc., must conform to good wiring practices and local codes. 1. Loosen the 3 lower terminal screws from the terminal block. 2. Insert the center bare wire (white/neutral) tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and then into the bottom center block opening. 3. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. 4. Tighten the screws until the wire is firmly secured (35 to 50 inch-lbs.). Do not overtighten the screws since it could damage the wires. 5. Go to Step 5 on page 6 to continue with the installation. 5 - English Install_NE63A6711_DG68-01359A-00_EN+MES.indb 5 2021-01-04 7:08:26