Samsung NQ70M6650DG/AA User Manual - Page 59

Replacing the oven door (Lower oven only) CAUTION The door is very heavy. You may need help lifting the door high enough to slide it into the hinge slots. Do not lift the door by the handle. WARNING You can't replace the upper oven door for safety reason. 1. Using two hands, grasp the side edges of the door at the midpoint. Face the oven cavity. 2. Locate the slots on each side of the oven cavity for the door hinge locks. A A. Slot in the oven cavity for the door hinge lock 3. Hold the door at a 45° angle, and then align the door hinges with the slots in the lower front of the oven cavity. Slowly insert the door, making sure you maintain the 45° angle. You will know the door is engaged in the slot when you feel a slight drop. 4. Lower the oven door to the fully open position. If the oven door does not open to a full 90°, repeat steps 1 through 3. 5. Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position. See Step 3 (illustration A) in the "Removing the oven door" section for the proper locked position. 6. Close the oven door. 7. When the hinges are properly installed and the door is closed, there should be an even gap between the door and the control panel. If one side of the oven door is hanging lower than the other, the hinge on that side is not properly installed. 8. Reconnect the Wire Harness and then re-install the rubber cap (for the upper oven door). CAUTION After replacing the door, make sure to reconnect the wires. Push them inward to arrange them as they were before you removed the door. Wires that are not connected or arranged correctly can be caught in the door or damaged by heat. Maintaining your appliance NQ70M6650DS_AA_DE68-04446A-02_EN+MES+CFR.indb 59 English 59 2018-08-30 12:52:39