Samsung PN42B400P3D Quick Guide (easy Manual) (ver.1.0) (English, French, Span - Page 7

Turning the TV On and Off Press the POWER button on the remote control. You can also use the POWER button on the TV. ➢ It may take a while for the picture to appear. Viewing the Displays and Menus Viewing the Display Press the INFO button on the remote control. The TV will display the channel, the type of sound, and the status of certain picture and sound settings. TV #1 DTV Air Dolby Digital 13-1 Fri, Dec 19 2:05 am M. Spillane's Mike Hammer Bonocrunch Next Program Prison Break 1080i 16:9 English 1:55 am - 2:55 am 2:55 am - 3:55 m Memorizing the Channels Your TV can memorize and store all of the available channels for both air and cable channels. After the available channels are memorized, use the CH or CH button to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (Channel Lists). Storing Channels in Memory (Automatic Method) Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i.e. an Air or a Cable system). Press the MENU button to display the menu. Press the ▲ or ▼ button to select Channel, then press the ENTERE button. Antenna : Air ► Auto Program Clear Scrambled Channel Channel List Fine Tune Channel Picture Viewing the Menus With the power on, press the MENU button. The main menu appears on the screen. The menu's left side has icons: Picture, Sound, Channel, Setup, Input, Support. Mode Cell Light Contrast Brightness Sharpness Color Tint (G/R) : Standard : 4 : 95 : 45 : 50 : 50 : G50/R50 Press the ▲ or ▼ button to select one of the icons. Then press the ENTERE button to access the icon's sub-menu. Press the EXIT button to exit. ➢ It takes about one minute until the on-screen menu disappears. Press the ▲ or ▼ button to select Auto Program, then press the ENTERE button. Auto Program Select the Antenna source to memorize. Air Start Cable Start Auto Start Move Enter Return Press the ▲ or ▼ button to select an antenna connection, then press the ENTERE button. ➢ Air: Air antenna signal. Cable: Cable antenna signal. Auto: Air and Cable antenna signals. Analog Digital Auto Program Select the cable system. STD HRC IRC STD HRC IRC Start Move Enter Return English - 7