Samsung RF26HFENDWW User Manual - Page 13

SETTING UP 4. After adjusting the doors, insert the supplied fastener ( 6 ) using a pliers ( 5 ) in the gap between the hinge-grommet ( 7 ) and the lower hinge ( 8 ). The number of fasteners you'll need to insert depends on the gap. TO USE WITHOUT THE WATER FILTER Connecting to the water supply line • Shut off the main water supply line and turn the Ice maker to the off position. • Locate the nearest cold water drinking line. 2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04". 1 7 2 654 1. Cold Water line 2. Pipe Clamp. 3. Plastic line 4. Compression Nut 3 5. Compression Sleeve 6. Packing Nut. 7. Shut Off Valve CONNECT THE WATER LINE TO THE FRIDGE • Connect the plastic line on the back of your fridge to the cartridge holder outlet (fully insert the plastic line to the cartridge holder outlet). • Insert plastic clip to the cartridge holder inlet and outlet. • Turn water on and check for any leakage. • You can purchase the necessary filter cartridge at the retailer where you purchased this refrigerator. • The water line must be connected to drinkable water only • A compression fitting and nut kit is supplied with the unit and it is inside the fridge drawer. • When pushing the Refrigerator back, make sure you don't roll over the power cord or water line(Icemaker supply line) Cartridge Holder Clip Plastic line (Provided) Filter cartridge Connect the water line to the fridge Household water line Copper tubing or Plastic tubing (Not supplied) (Not supplied) Ferrule (Purchased) Compression nut (1/4") (Purchased) Bulb Plastic Tubing (Provided) Refrigerator Compression Fitting (Provided) Compression Nut (1/4") (Provided) 1. Slip the compression nut through the plastic tubing. 2. After inserting the compression nut into plastic tubing, tighten the compression nut onto 1/4" compression fitting(Provided). English - 13 DA68-02601C-00.indb 13 2014. 8. 18. 8:46