Samsung RF28HDEDBSR User Manual Ver.01 (English, French, Spanish) - Page 26
Ice Making, If There is a Power Failure, Using the ice off Function - problems
View all Samsung RF28HDEDBSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Ice Making To fill the ice bucket to maximum capacity after installation, follow these steps: 1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day). -- Waiting 24 hours will allow your ice maker to cool properly. 2. Dispense 4 to 6 ice cubes into a glass. 3. After 8, and then 16 hours, dispense a full glass of ice. CAUTION • To clean the ice bin/bucket, wash with a mild detergent, rinse well, and then dry it thoroughly. Do not use harsh or abrasive cleaners or solvents. • When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced. If you use all the ice at once, you must repeat Steps 2 and 3 under Ice Making. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production. Using the ice off Function When you select the Ice Off mode, remove all ice cubes from the bucket. If you leave the ice cubes in the bucket, the ice cubes may clump together, making it difficult to remove them. To remove the ice bucket safely and avoid injury, hold the bottom of the bucket with one hand and the side of the bucket with the other. Then, lift up on the ice bucket, and pull it straight out. To put the ice bucket back in, push it firmly straight back. If There is a Power Failure If a power failure occurs, ice cubes may melt, and then freeze together when the power comes back on, preventing the dispenser from working properly. To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water. After you dump the ice from the ice bucket, you should press the dispenser lever once with the 'Water' or 'Ice Type' function ON. The ice maker will make new ice faster after you return the ice bucket to the refrigerator. If the ice bucket is not pushed firmly into place, ice in the bucket can melt. If the bucket does not fit, turn the helix 90 degree (see the last illustration on the right, below) and try again. CAUTION • The inside of the ice bucket is very cold when the refrigerator is operating. Do not reach deep inside the ice bucket. • Use only the ice maker provided with the refrigerator. The water supply to this refrigerator must only be installed/connected by a suitably qualified person. Connect to a potable water supply only. • To operate the ice maker properly, water pressure of 20 ~ 125 psi is required. DA68-03029A-01.indb 26 English - 26 2014. 3. 19. �� 9:24