Samsung RFG293HARS User Manual (user Manual) (ver.0.3) (English) - Page 9

ACCESSORIES AND REQUIRED TOOLS Make sure the following accessories are included with your refigerator : 01 SETTING UP Hex wrench Fastener Compression fitting Compression nut Required Tools (Not provided) You need the following tools to complete the installation of your refirgerator: Philips screwdriver(+) Flat-blade screwdriver(-) Socket wrench (10mm) Pliers Allen wrench(3/16") (5mm) Removing the refrigerator doors Some installations require door removal to transport the refrigerator to its final location. Do not remove the door/drawer if you don't need to. If you do not need to remove the refrigerator doors, go to adjusting the level. If you need to remove the doors. continue below. Before removing the door/drawer make sure you read following items : Disconnect power to the refrigerator before removing the door or drawer. WARNING • B e careful not to drop, damage or scratch the door/drawer while removing them. • B e careful not to get injured while removing the door/drawer. • R eattach the door/drawer properly to avoid: - Moisture from air leakage. - Uneven door alignment. - Wasting energy due to improper door seal. Disassemble the refrigerator doors Be careful not to drop and scratch the doors while WARNING removing the doors. Disassemble the refrigerator doors 1. With the door opened, remove the cap top table ( 1 ) with 2 a flat-blade screwdriver(-), and close the door. Remove the 3 screws holding down the top table ( 2 ) and turn it over with several wires connected. 1 Setting Up _9