Samsung RS2555BB User Manual (user Manual) (ver.1.0) (English) - Page 28

Remove any residual matter inside the water supply line after installing filter., Check the amount

Page 28 highlights

DA68-00500T(12.030)4.1.230:페5P이9M지28 INSTALLATION OF THE WATER DISPENSER LINE Remove any residual matter inside the water supply line after installing filter. 1) Turn on the main water supply & shut-off valve of the water supply line. ICE 2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines. 3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around the water filter. WATER • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine self (RS2577). Check the amount of water supplied to the ice tray. 1) Lift up (x) and pull out (➁) the ice maker bucket in the freezer. ICE MAKER 2) When you press the test button, the ice cube container is filled with water from the water supply tap. Check the amount of water (see the illustration below). If the water level is too low, the ice cubes will be small. CHECK THE WATER LEVEL This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the amount of water supplied. TEST BUTTON TOO HIGH OPTIMUM LEVEL TOO LOW 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

WATER
ICE
28
2) When you press the test button, the ice cube container is
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker
but of the water pressure in
the pipe, and occurs frequently.
When this problem occurs, contact
the dealer service center to check the
amount of water supplied.
INSTALLATIONOF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
Check the amount of water supplied to the ice tray.
1) Lift up (
) and pull out (
) the ice maker bucket in the freezer.
ICE MAKER
1) Turn on the main water supply & shut-off valve of the water
supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
Before reinstalling the water filter, remove the wine self (RS2577).
NOTE
CHECK THE WATER LEVEL
TEST BUTTON
TOO HIGH
OPTIMUM
LEVEL
TOO LOW
DA68-00500T(1.3)
2004.1.20
3:59
PM
페이지28