Samsung SC-148A User Manual (user Manual) (ver.1.0) (English) - Page 10
Connecting the power cable - support
View all Samsung SC-148A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Setup a : Master Drive (Choose the MA Jumper) c : MainBoard e : Secondly 1 b : Hard Drive d : Primary 1 If there is two CD-ROM drive, select MA (Master) / SL (Slave). a : Master Drive (Choose the MA Jumper) b : Slave Drive (Choose the SL Jumper) c : Hard Drive d : MainBoard e : Primary 1 f : Secondly 1 Installing a jumper on the master/slave select terminal Connect a jumper to the rear side of the CD-ROM. If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode. If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended.) Connecting the audio cable from a sound card Connect the 4-pin audio cable between the sound output terminal on the CD-ROM drive and the audio input terminal on the sound card. For clearer sound, use a digital output terminal.(Available only for the CAID that supports digital output) This may not be available for general sound cards.