Samsung SHR-6042 User Manual - Page 42
Primary Address & Secondary Address, Connection Status, Success, Failed, NTP Enable, Enable
UPC - 836164370297
View all Samsung SHR-6042 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
If you have set a public DDNS (dyndns.com, noip.com or changeip.com), it may take 30 to 60 seconds until the IP address of the host name (URL) can be updated in the DNS. When using the network by connecting an IP router to the main system, the network port has to be designated from the setup menu of the IP router. The main system uses 1494ports (554-2048) for the TCP communication. When using it by assigning IP addresses dynamically to the main system while using the DHCP function supported by the IP router, the port number for the IP address dynamically assigned from the setup menu of the IP router needs to be designated. When using an IP router, it is recommended to designate the IP address and port number to be assigned to the main system from the setup menu of the IP router, to set a fixed IP address for the connection mode of the main system, and to enter the IP address designated to the IP router. Please refer to the IP router manual or contact the manufacturer for the IP router setup method. NTP Setup NTP Setup Primary Address Secondary Address Connection Status pool.ntp.org asia.pool.ntp.org NTP Enable trying.. 0% OK Test Cancel Move/Control Select Exit NTP Setup is used to configure the system for networkbased synchronization. Primary Address & Secondary Address Sets the NTP server address. Connection Status You can check the connection status with the NTP server by pressing "Test" after entering the NTP server address. If the message "Success" is displayed, the NTP server is in the state possible to communicate; if the message "Failed" is displayed, it is not possible to communicate. NTP Enable When using the NTP function, please check the "NTP Enable" box. When the DVR system time prior to operating the NTP setup function is set faster than the NTP standard time (in other words, the DVR system time is set to a past time through the NTP setup), the recording function will not operate for the protection of previously recorded data. The recording function will operate normally from the point that the newly set time exceeds the original time value. When the NTP function is in use, a time change can not be made from the time setup menu and it only allows setting the standard time zone. The synchronization between NTP server and DVR system will be performed every hour. 38_ menu setup