Samsung SL50 User Manual (user Manual) (ver.1.1) (English) - Page 13
Connecting to a Power Source - cable
UPC - 044701013204
View all Samsung SL50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connecting to a Power Source You should use the rechargeable battery BP70A supplied with the camera. Be sure to charge the battery before using the camera. Ê BP70A rechargeable battery Specification Model BP70A Type Lithium lon Capacity 740mAh Voltage 3.7V Charging time Approximately 150 Minutes Ê Number of images and battery life: Using the BP70A Battery life / Number of images Conditions Using the fully charged battery, Default settings, Program mode, Shot to shot interval: 30Sec. Still image Approx. 105 MIN / Approx. 210 shots Changing the zoom position between the Wide and the Tele after every shot. Using the flash on every second shot. Using the camera for 5 minutes and then powering it off for 1 minute. Movie Using the fully charged battery Approx. 105 MIN 640x480 image size 30fps frame rate Ä These figures are measured under Samsung's standard conditions and shooting conditions and may vary depending on the user's methods. 012 Important information about battery usage. å W hen camera is not in use, turn off the power. å P lease remove the battery if the camera will not be used for long periods. Batteries can lose power over time and are prone to leaking if kept inside the camera. å L ow temperatures (below 0°C) can affect the performance of the battery and you may experience reduced battery life. å Batteries will usually recover at normal temperatures. å D uring extended use of the camera, the camera body may become warm. This is perfectly normal. Ê Connecting the AC adapter with the USB cable can be used as an AC cable, and you can charge the rechargeable battery with the AC cable. - Using an AC cable : Connect the AC adapter to the USB cable. It can be used as a power cable. - Using a USB cable : Remove the AC adapter. You can download stored images to your PC (p.89) or supply the power to your camera through the USB cable.