Samsung SM-308B User Manual (user Manual) (ver.1.0) (English) - Page 5
Connecting the Cables
View all Samsung SM-308B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Connecting the Cables 1. Power cable 2. Master/slave select terminal 3. IDE cable 4. Audio cable 1 Connecting the power cable The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the COMBO drive. 2 Installing a jumper on the master/slave select terminal Install the jumper in the correct position on the terminal: MA to use the device in the master mode SL to use the device in the slave mode CS to control the device via a CSEL host interface signal See Step 3 for further details. 3 Connecting the IDE cable Two configurations are possible. q The COMBO drive is the only IDE device in addition to the hard disc. IDE port Mother board COMBO Hard disc (SL) (MA) Install the jumper in the SL position (Slave). Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to the COMBO drive and then to the hard disc. 6 q You already have an additional IDE device installed in your computer. Second IDE cable First IDE cable COMBO CD-ROM (MA) (SL) Mother board Hard disc (SL) Hard disc (MA) Install the jumper in the MA position (Master). Connect the 40-pin flat IDE cable from a second IDE port on the mother board directly to the COMBO drive or first to another additional IDE drive and then to the COMBO drive. 4 Connecting the audio cable from a sound card Connect the 4-pin audio cable between the sound output terminal on the COMBO drive and the audio input terminal on the sound card. 7