Samsung SP-D300B User Manual (user Manual) (ver.1.0) (English) - Page 10
system is not in normal - projector lamp
View all Samsung SP-D300B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Power Cable Sold separately D-Sub Cable Remote Control/ 1 Batteries (Not available in all locations) Cleaning Cloth LED Indications ●:Light is On ◐:Light is Blinking ○:Light is Off STAND LAMP BY TEMP Information ● ○ If you press the POWER button on the remote control or projector, the screen ○ appears within 30 seconds. ● ● ○ The projector is in normal operating condition. ● ◐ This state appears when the projector is preparing an operation after the POWER button ○ on the projector or the remote control has been pressed. ○ ◐ The POWER button is pressed to turn off the projector, and the cooling system is in ○ operation to cool off the inside of the projector. (Lasts for about 1 minute and 30 seconds) ◐ ○ Refer to Action 1 below if the cooling fan inside the projector is not in normal operation ◐ condition. ○ ◐ Refer to Action 2 below if the lamp cover protecting the lamp unit is not closed ◐ properly. ○ ○ Power is turned off automatically when temperature inside of the projector goes beyond ◐ the control limit. Refer to Action 3. ● ◐ ◐ A problem has occurred when operating the DDP IC in the product. Refer to Action 4. ◐ ◐ ◐ A problem has occurred with the operation of the lamp. Refer to Action 5. ● ◐ ● The lifetime of the lamp has expired. Refer to Action 6. ◐ ◐ ○ The memory in the product is not operating normally. Contact a service center. ◐ ◐ ● The power for the product is not operating normally. Contact a service center. ◐ ● A problem has occurred when operating the color wheel in the product. Refer to Action ◐ 4. Clearing Indicator Problems Classification State Action 1 When the cooling fan system is not in normal operating condition. Action 2 When the lamp cover protecting the lamp unit is not properly closed or the sensor system is not in Measures If the symptom remains even after disconnecting and then reconnecting the power cord and turning the projector on again, contact your product provider or our service center. Check whether the screws at the bottom side of the projector are fastened correctly. If they are abnormally fastened, contact your product distributor or service center.