Samsung SP-D300B User Manual (user Manual) (ver.1.0) (English) - Page 11
powering on right after - projector
View all Samsung SP-D300B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Action 3 Action 4 Action 5 Action 6 normal operating condition. When temperature inside of the projector becomes too high. When the color wheel fails to operate. The lamp malfunctions after power turns off abnormally or after powering on right after turning off the projector. When the screen becomes darker Adjust the installation state of your projector by referring to the Installation Precautions section listed above. Cool down your projector sufficiently and then operate it again. If the same problem occurs continually, contact your product distributor or service center. Disconnect and reconnect the power cord and start the projector again. If the same symptom still occurs, contact your product distributor or service center. Turn the power off, wait for a sufficient amount of cooling time and then turn the power on to operate. If the same problem occurs continually, contact your product distributor or service center. Check the lamp usage time on the Information Display screen. If you need to replace the lamp, contact your product distributor or service center. This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance and is part of normal operation. Rear Side 1. RS-232C port (For service input terminals) 6. HDMI/DVI IN Input port 2. SERVICE Input port 7. MONITOR OUT terminal 3. VIDEO IN Input port 8. PC IN Input port 4. S-VIDEO IN Input port 9. COMPONENT IN Input port 5. Remote Control Signal Receiver 10.POWER Input port