Samsung SR1AM7040WG User Manual - Page 36

I I Troubleshooting The POWERbot is not working at all. al Checklist o Check if the emergency switch is on. o Check if all the icons are displayed on the display panel. o Check if the POWERbat's battery is depleted. - When "Lo' is displayed, place the POWERbot on the docking station to charge it. - When the battery indicator blinks. manually place the POWERbot on the docking station to charge. (Only SR1AM7010UW series) o Replace the batteries (AAA type) if the remote control is not working. The POWERbot has stopped during cleaning. o When "Lo" is displayed on the display panel, place the POWERbot on the docking station to charge it. o When the battery indicator blinks, manually place the POWERbot on the docking station to charge. (Only SR lAM7010UW series) o When POWERbot is immobilized by an obstacle such as a cord, threshold etc. pick it up and move it away from the obstacle. - If any fabric or string is caught in a drive wheel. turn off the emergency switch and remove the fabric or string before using it again. Suction power is weak. o if the "Filter inspection indicator" is on, turn off the emergency switch and clean the dustbin. o When there's too much dust in the dustbin, suction power may get weakened. Turn off the emergency switch and empty the dustbin. o If the intake (on bottom of POWERbot) is blocked by foreign matter, turn off the emergency switch and remove foreign matter from the intake. 0 When noise suddenly increase, turn off the emergency switch and empty the dustbin. The POWERbot cannot find the docking station. o Check if there's a power failure or whether the power plug is unplugged. 0 Remove any obstacles around the docking station that may prevent POWERbot from returning to the docking station. o When there's foreign matter on the charge pins, charging can be affected. Clean the foreign matter off the pins. The POWERbot suddenly cleans diagonally. o Check if the docking station is installed along the grain of wooden floors or tiles. o The POWERbot may clean in a diagonal direction if it is moving to another area using the shortest route. It may also move at a diagonal if it made contact with an obstacles at that angle, if it was charged at the docking station at an angle. or if the grain of the wooden/tile floor skewed is in that direction. o If you point the red light directly at POWERbot, it may not move in desired direction. Point cleaning is not working. - Point the red light on the floor within 1.6 ft (0.5 m) of POWERbot. *Do not use point cleaning in direct sunlight, under bright light, or on dark floors. ENGLISH-36 IVR7000_66_0J66-00763C-02_USA.Indd 39 3017-07.23 2N 12:214