Samsung STP-103P User Manual - Page 15
Control Commands
View all Samsung STP-103P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Command Name Esc c 5 Esc d Esc t Esc { Enable/disable panel FEED buttons Print and feed paper n lines Select character code table Turn upside-down printing mode on/off Command Classification Execution Setting 0 0 0 0 FS p FS q GS ! Print non-volatile bit image Define non-volatile bit image Select character size 0 0 0 GS * Define downloaded bit image 0 GS / Print downloaded bit image 0 GS : Start/end macro definition 0 0 GS B Turn white/black reverse printing mode on/off 0 GS H Select printing position of HRI characters 0 GS I Transmit print ID 0 GS L Set let margin 0 GS P Set vertical and horizontal motion unite 0 GS W Set printing area width 0 GS ^ Execute macro 0 0 GS a Enable/disable Automatic Status Back 0 0 GS b GS f GS h Turn smoothing mode on/off Select font for HRI characters Set bar code height 0 0 0 GS k GS v GS w Print bar code Print raster bit image Set bar code width 0 0 Standard Mode 0 0 0 0 0 0 (0) • 0 0 0 0 (0) 0 (0) 0 0 0 0 0 ( 0 0 Command classification Executing : Printer executes the command, which does not affect the following data. Setting : Printer uses flags to make setting, and those setting affect the following data. Standard mode ○ : Enabled (○) : Enabled only when the command is used at the beginning of a line. ● : Enabled only when data is not present in the buffer. X : Disable 28 Chapter 9. Control Commands Command Notation XXXX Command [Name] The name of the command. [Format] The code sequence. ASCII indicates the ASCII equivalents. Hex indicates hexadecimal equivalents. Decimal indicates the decimal equivalent. [ ]k indicates the contents of the [ ] should be repeated k times. [Range] Gives the allowable ranges for the parameters. [Description] Describes the function of the command. [Notes] Provides important information on setting and using the printer command, it necessary. [Default] Gives the default values, if any, for the command parameters. [Reference] Lists related commands. [Example] Provides examples using the command. The numbers followed by H are hexadecimal The numbers followed by B are binary. The numbers denoted by ( ) are decimal. Explanation of Terms LSB Least Significant Bit Control Commands HT [Name] [Format] [Description] Horizontal tab ASCII HT Hex 09 Decimal 9 Moves the print position to the next horizontal tab position. LF [Name] [Format] [Description] Print and line feed ASCII LF Hex 0A Decimal 10 Prints the data in the print buffer and feeds one line based on the current line spacing. 29