Samsung SWA-W500/ZA User Manual - Page 9

NOTE -- If the SWA-W500 does not connect, take the necessary steps shown below according to the LED Indicator's status. LED status Action On Connected with the Soundbar - Blue Blinking ID SET status Check if the power cable attached to the main Soundbar unit is connected properly or wait about 5 minutes. If blinking persists, repeat steps 3 through 4. Standby (with the Soundbar main unit turned off) Check if the Soundbar is turned on. 1. Press the ID SET button on the rear of the Wireless Subwoofer with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). Red On Connection failed ID SET 5 Sec Others - Errors POWER ID SET 2. Repeat steps 3 through 4. Contact a Samsung Service Center. Compatible Models HW-S60T HW-S66T HW-S61T HW-S67T •• The model list is subject to change without further notice. •• To check compatability with Soundbars to be released after 2020, please refer to the FULL MANUAL of the Soundbar (http://samsung.com/support). ENG - 9