Samsung WA456DRHDSU/AA User Manual Ver.1.0 (English) - Page 32
troubleshooting - washer unbalanced when empty
View all Samsung WA456DRHDSU/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
troubleshooting PROBLEM Fills with the wrong temperature water. Lid locked or will not open. Does not drain and/or spin. Load is too wet at the end of the cycle. Leaks water. Has excessive suds. SOLUTION • Turn both faucets on fully. • Make sure the temperature selection is correct. • Make sure the hoses are connected to the correct faucets. Flush water lines. • Disconnect the hoses and clean the screens. The hose filter screens may be plugged. • As your washer is filling, the water temperature may change as the automatic temperature control feature checks incoming water temperature. This is normal. • While your washer is filling, you may notice just hot and/or just cold water going through the dispenser when you have selected cold or warm wash temperatures. This is a normal function of the automatic temperature control feature as your washer determines the temperature of the water. • Press the Start/Pause button to stop your washer. • It may take a few moments for the lid lock mechanism to disengage. • Check the fuse or reset the circuit breaker. • Straighten the drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service. • Close the lid and press the Start/Pause button. For your safety, your washer will not spin unless the lid is closed. • Use the High spin speed. • Use high efficiency detergent to reduce over-sudsing. • The Load is too small. Very small loads (one or two items) may become unbalanced and not spin out completely. • Make sure all hose connections are tight. • Make sure the end of the drain hose is correctly inserted and secured to the drainage system. • Avoid overloading. • Use high efficiency detergent to prevent over-sudsing. • Use high efficiency detergent to prevent over-sudsing. • Reduce the detergent amount for soft water, small or lightly soiled loads. • Non-HE detergent is NOT recommended. 32_ troubleshooting