Samsung WA484DSHAWR/A1 User Manual Ver.1.0 (English, French, Spanish) - Page 18
Step 3, Step 4, Step 5
View all Samsung WA484DSHAWR/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
installing your washer STEP 3 Leveling your washer See if the washer is level by checking the position of the tub: 1. Slide the washer into position. 2. Open the lid of the washer, and pour the water into the tub to just below the pulsator level. Pulsator Loosen Lock Adjustable legs 3. If the washer is level, the pulsator is positioned at the center of the water as shown in the figure. If not, level your washer by turning the front leveling feet in or out as necessary. Turn the front leveling feet clockwise to raise the height, and counter clockwise to lower the washer. STEP 4 Powering your washer Plug the power cord into a 3-prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded electrical outlet. STEP 5 Running a test cycle Run a test cycle as follows to check if your washer is properly installed. 1. Load your laundry (6 pounds) into the tub. 2. Press the Power button to turn on your washer. 3. Select the Rinse+Spin cycle by turning the Cycle Selector. 4. Press the Start/Pause button to start the test cycle. 5. Check if the washer does not rock or vibrate excessively while water is supplied, and that it drains well during the spin cycle. If there are any malfunctions such as a water leakage while water is supplied or drained, check the water connection, referring to the "Connecting the water and the drain" section on page 16~17. If the washer rocks and vibrates excessively, level your washer again, referring to the "Leveling your washer" section on page 18. 18_ installing your washer WA484DSHA-03050D_EN.indd Sec3:18 2012-07-02 3:39:21