Samsung WF398ATPAWR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 18
Installing your Washer
View all Samsung WF398ATPAWR/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
installing your washer STEP 3 Installing your Washer 1. If you use a stand pipe, make sure the connection between the drain hose and the standpipe is NOT airtight. The standpipe must be at least 18 in or 46 cm high. You must always exercise caution to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive length. For situations where the drain hose cannot 96" Max 18" Min be conveniently elevated to at least 18 in or 46 cm, the drain hose must be supported. Do not insert the drain hose too far into the stand pipe: 6 - 8 inches, and no more. Laundry tub Stand pipe Hose retainer Tie strap 96" Max 18" Min 2. Check the inlet hose to ensure a washer is inside each fill hose. Cold Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and attach each fill hose to the water valve. Make sure the hose with Hot printed on it is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. Hot Rubber Washer For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. 3. Turn on the "HOT" and "COLD "water supply and check the water Cold printed Hot printed valve and the water supply connections for leaks. 18_ Installing your washer 8'"51 JOEE