Samsung WF419AAW User Manual (ENGLISH) - Page 11

01 Installing your washer STEP 3 Installing your Washer 1. Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18in.(46 cm) high. Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive lengths. For situations where the drain hose cannot be conveniently elevated to at least 18in.(46 cm), the drain hose must 96" Max be supported. 18" Min Laundry tub Hose Guide Stand pipe Hose retainer Tie strap 96" Max 18" Min 2. Insert a new rubber washer (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings. Rubber Washer 3. Check the inlet hose to ensure a washer is inside each fill hose. Cold Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. Hot Rubber Washer For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. Cold printed 4. Turn on the "HOT" and "COLD "water supply and check all connections at the water valve and the faucet for leaks. Hot printed BEST-WF419AAW-02657A_EN.indd 11 Installing your washer _11 2009-02-18 ¿ÀÈÄ 3:26:45