Samsung WF50A8600AE User Manual - Page 49
Maintenance, Self Clean
View all Samsung WF50A8600AE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
English Maintenance Keep the washer clean to prevent deteriorated performance and to preserve its life cycle. WARNING Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing. Service personnel - Do not contact the following parts while the appliance is energized: Control board, heat sink, motor, inlet valve and pump. Self Clean+ Certain usage and environmental conditions may result in some residue build-up or odor in the washer drum. To prevent this build-up or odor and keep your washer drum fresh and clean, perform the Self Clean+ cycle at least once a month or every 40 cycles. Perform the recommended procedure below when using the Self Clean+ cycle. 1. Tap . 2. Turn the Navigation dial to select Self Clean+. 3. Tap and hold . CAUTION If there is chlorine bleach left in the washer drum for an extended period of time, rust can occur. NOTE • The water temperature for Self Clean+ is defaulted to Extra Hot. This temperature cannot be changed. • In the case where residue is present in the washer drum, add liquid chlorine bleach to the MAX level line in the main-wash compartment before starting the Self Clean+ cycle. Do not add the liquid chlorine bleach to the bleach compartment (This is only the case for Self Clean+ cycle). • Do not exceed the max line. Do not use or mix any other detergent or chemicals during the Self Clean+ cycle. If necessary, run a Rinse+Spin cycle after the Self Clean+ cycle has completed to help remove any remaining residue. Self Clean+ reminder • After every 40 cycles, the washer displays the "Drum Clean needed" message for an hour to alert you to run the Self Clean+ cycle. • It is recommended to run the cycle regularly for hygienic purposes. • You will see the Self Clean+ alert message when the washer completes a cycle. If you open the door, the message disappears, and the display shows the Self Clean+ cycle setting screen automatically. At this time, the dryer control panel displays the recommended drying cycle. • The reminder will appear on the control panel for 5 additional consecutive cycles before turning off. The next reminder will not appear until another 40 cycles have been completed. Untitled-1 49 English 49 2021-02-09 2:17:11