SanDisk SDCFX-256-786 Product Manual - Page 68
Idle Immediate-95H, E1H, Initialize Drive Parameters-91H
UPC - 619659018795
View all SanDisk SDCFX-256-786 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
ATA Command Description SanDisk CompactFlash Card OEM Product Manual 5.1.7 Idle Immediate-95H, E1H This command causes the card to set BSY, enter the Idle (Read) mode, clear BSY and generate an interrupt. Table 5-14 Idle Immediate Bit 7 6 5 4 3 2 1 0 Command (7) E1H or 95H C/D/H (6) X Drive X Cyl High (5) X Cyl Low (4) X Sec Num (3) X Sec Cnt (2) X Feature (1) X 5.1.8 Initialize Drive Parameters-91H This command enables the host to set the number of sectors per track and the number of heads per cylinder. Only the Sector Count and the Card/Drive/Head registers are used by this command. NOTE: SanDisk recommends not using this command in any system because DOS determines the offset to the Boot Record based on the number of heads and sectors per track. If a CompactFlash Memory Card is "Formatted" with one head and sector per track value, the same card will not operate correctly with DOS configured with another heads and sectors per track value. Table 5-15 Initialize Drive Parameters Bit Command (7) C/D/H (6) Cyl High (5) Cyl Low (4) Sec Num (3) Sec Cnt (2) Feature (1) 7 6 5 4 3 2 1 0 91H X 0 X Drive Max. Head (no. of heads - 1) X X X Number of Sectors X 02/07, Rev. 12.0 5-14 © 2007 SanDisk Corporation