Sanyo CE42LM4WPN-NA Owner's manual - Page 5

Terminals INSTALLATION During menu operation, the bottom of the screen will show which controls can be used. Press the u button to enter the main menu. Main Menu Picture Setting 1 2 1. The LCD display will have a Standby light to show there is power. 2. Control buttons (bottom edge of cabinet) Menu/F button: rotate between contrast, Brightness, color and sharpness Input/OK button: switch between AV1, RGB, AV2, AV3, HDMI and PC mode. e d buttons: adjust Menu/F options 4 button: To switch from display to standby mode (to switch off completely disconnect the monitor from the power supply) Menu Operation Many of your monitors functions are controlled through the menu function. Brightness Contrast Color Sharpness Preset Personal / Dynamic / Standard / Eco Noise Reduction Mid / Max / Auto / OFF / Min Dyn. Skin Tone ON / OFF Text Brightness Max / Mid / Min Child lock Timer AV2 setting OFF / ON Off Time ON / OFF RGB, H/V / Y Pb Pr : Select : Adjust MENU : Exit A sub menu is selected using the e or d button and pressing the 8 button when the required sub menu is highlighted. When you have set a Sub menu you can press the MENU button to exit, then the MENU button again to exit the main menu. Picture menu Picture Brightness Contrast Color Sharpness Preset Noise Reduction Dyn. skin tone Text Brightness : Select Personal / Dynamic / Standard / ECO Mid / Max / Auto / Min / OFF ON / OFF Min / Mid / Max : Adjust MENU : Back 1. Press the MENU button. Select Picture using the e or d button. Press the 8 button to enter. Set the picture settings for your "personal" preference. 2. Use the e or d button to select e.g. Brightness and the 7 or 8 button to adjust levels. 3. Preset : You can select either your "Personal" settings, or Dynamic, Standard or Eco settings. 4. Noise Reduction: May be used to reduce any local picture 'noise' (granular appearance) being experienced by Using 7 or 8 to select between Mid / High / Auto / Low / OFF. 5. Dynamic skin tone: May be used to enhance skin tone by using 7 or 8 to select between On / Off. Tint : is only available if NTSC equipment is connected. 6. Text Brightness: May be adjusted by Using 7 or 8 button to select between Min / Mid / Max. To exit press the MENU button. ✐ Your personal settings are automatically saved when you exit the menu. 5