Sanyo DP32649 DP32649 Manual - Page 5

STAND REMOVAL AND WALL MOUNTING (OPTIONAL) Tools Needed: Phillips screwdriver IMPORTANT NOTE: Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person. 1 Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw. 2 Use the screws you removed when detaching the stand to secure the HDTV to a wall mounting kit (not included.) VESA standard interface: 200 x 200 Mounting screws measurements: M6 (6mm) Diameter, Length-16mm (maximum) PROTECTING THE LCD SCREEN The screen can be damaged if it is not maintained properly. Do not use hard objects such as hard cloth or paper. Do not use excessive pressure when cleaning the screen; excessive pressure can cause permanent discoloration or dark spots. NEVER spray liquids on the screen. GETTING STARTED BATTERY INSTALLATION Install batteries in the remote control ( 2 "AAA", not included) PRECAUTIONS To ensure safe operation, please observe the following precautions: • Replace both batteries at the same time. Do not use a new battery with a used battery. • There's a risk of explosion if a battery is replaced by an incorrect type. • Do not expose the Remote Control unit to moisture or heat. • Be sure to match the "+" and "-" signs on the batteries with marks inside the remote control. ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE ANTENNA ANALOG / DIGITAL ANTENNA IN CABLE The tuner in this HDTV can receive: • Digital and Analog off air signals from an antenna • Analog or ClearQAM cable channels from a direct Cable TV connection. Need help? www.sanyoctv.com 1-800-877-5032 5