Sanyo DP55441 Owners Manual - Page 31

English Output terminals Digital Audio Output 1 Audio Output 1 CONFIGURATIONS OF VGA TERMINALS VGA IN (D-SUB) TERMINAL Terminal : D-SUB15 PIN Connect video output terminal of LCD TV to this terminal with a VGA Cable (not supplied). When connecting Macintosh computer, the MAC Adapter (not supplied) is required. 1 Red Input 9 2 Green Input 10 3 Blue Input 11 4 Reserved 12 5 Reserved 13 6 GND 14 7 GND 15 8 GND PC / HDMI SIGNAL MODES +5V NC Sense 0 DDC_SDA Horiz. sync. Vert. sync. DDC_SCL This LCD TV can correspond to the signals below. After connecting with the computer, the TV can automatically recognize the signal from the connected PC (computer) / HDMI. PC SIGNAL MODE COLUMN (recommended)® SYSTEM MODE VGA SVGA XGA WXGA WXGA SXGA Resolution 640x480 800x600 1024x768 1360x768 1280x768 1280x1024 V-Freq.(Hz) 59.94 60 60 60 60 60 H-Freq.(KHz) 31.47 37.88 48.36 47.712 47.78 63.981 PIXELS CLOCK (MHz) 25.18 40 65 85.5 79.5 108 NOTE: ■■ In principle, the TV can not display signal modes not described in the above column. However, it can sometimes display a signal very similar with one of the modes described. ■■ It is not the trouble of the TV if interference appears on the picture while switching the signal mode. ■■ The Dot Clock of the computer's signal must be less than 108 MHz. ■■ When the input signal from PC is out of the PC signal mode column, above, "No Support" caution message will display. But in some case, the LCD TV will still display the PC signal though the signal mode doesn't exist on the list above. Under this condition, the display position may not correct and the quality may not be admitted also. When input signal is digital from HDMI terminal, refer to the chart below. SYSTEM MODE 480I 480P 720P/60 1080I/60 1080P/24 1080P/60 Resolution 720(1440)x480 720x480 1280x720 1920x1080 1920x1080 1920x1080 V-Freq.(Hz) 59.94 59.94 60 60 24 60 H-Freq.(KHz) 15.73 31.47 45 33.75 27 67.5 PIXELS CLOCK (MHz) 27 27 74.25 74.25 74.25 148.5 30