Sanyo EMS9515W Owners Manual - Page 9

SET UP INSTALLATION Remove all packing material and accessories. Examine the oven for any damage such as dents or broken door. Do not install if oven is damaged. Do not remove the light brown Mica cover that is attached inside the oven cavity to protect the magnetron. NOTE: This unit is not designed for 50 Hz or any circuit other than a 120-volt/ 60-Hz AC circuit. This oven is designed for countertop installation. Countertop Installation 1. Select a level surface that provides enough open space for the intake and/or outlet vents. • Leave a minimum clearance of 3 inches above the oven. • Do not remove the legs from the bottom of the oven. 3" 3" • • 3" OPEN Blocking the intake and/or outlet openings can damage the oven. Place the oven as far away from radios and TV's as possible. Operation of microwave oven may cause interference to your radio or TV. A minimum clearance of 3 inches is required between the oven and any adjacent wall. One side must be open. • If the cabinet is covered with a protective film, remove the film. 2. Plug your oven into a standard 120-volt / 60-Hz household outlet. Be sure the electrical circuit is at least 15 amperes and that your microwave oven is the only appliance on the circuit. WARNING: Do not install oven over a range cooktop or other heat-producing appliance. If installed near or over a heat source, the oven could be damaged and the warranty would be void. 9