Sanyo FXCD-1100 Owners Manual - Page 10
Cd Player Or Cd Changer* Selection Button
UPC - 086483041655
View all Sanyo FXCD-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ELECTRONIC CONTROL RESET Press the SEL button ➁ for about 3 seconds until the unit beeps, the audio controls, except for volĆ ume, will be reset. BASSXPANDER (BASX) - 1/2 4 BASSXPANDER is a dual-mode sound equalization feature. Press button ➃ to select the BASSXPANDER modes as follows; b-1 b-2 OFF BASSXPANDER offers two preset modes: b-1 enhances the low and high frequencies, while b-2 enhances the low frequencies and reduces the high frequencies. RADIO SELECTION BUTTON (BAND 5 Press the BAND button ➄ to switch from tape, CD player or CD changer mode to radio. Each time the button is pressed, the function changes as shown below. FMI FMII AM TAPE SELECTION BUTTON ( 7 Press button ➆ to switch from radio, CD player or CD changer mode to tape mode. CD PLAYER OR CD CHANGER* SELECTION BUTTON (CD/CD-CH 6 Press the CD/CD-CH button ➅ to switch from radio or tape mode to CD player or CD changer* mode. * If a CD changer is connected. Pressing the button will change the mode as follows: 1 When a CD is loaded in the CD player and a CD changer is not connected; Radio/Tape CD player CD player pause 2 When a CD is not loaded in the CD player and a CD changer is connected; Radio/Tape CD changer CD changer pause 3 When a CD is loaded in the CD player and a CD changer is connected; Radio/Tape CD player CD changer CLOCK BUTTON (DISP 8 Press the DISP button ➇ to switch between the clock and audio display. When an audio function is performed while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the time mode. TO CANCEL THE BEEP TONES 7 1 To cancel all beep tones, press button ➆ for more than 3 seconds with no tape in the slot, and then is displayed. 2 To turn on the beep tones again, perform the same procedure. The beep tones are set and played. -ā8ā- is disĆ