Sanyo FXCD-1100 Owners Manual - Page 23
Troubleshooting - service manual
UPC - 086483041655
View all Sanyo FXCD-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
TROUBLESHOOTING Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with the unit. Before having the unit serviced, refer to the troubleshooting chart below. Symptom The compact disc or tape does not play when inserted into the unit. No power. The unit does not work properly (Eject, Load, Play). The sound from the CD player skips. No radio reception. The radio does not stop on any stations when automatic tuning is used. Cause Solution The volume control is turned down. Turn up the volume control. The power connections are Check the +12V and ground not wired correctly. connections. The vehicle ignition is switched off. Switch the ignition to the ON" or ACC" position. The fuse is blown. Replace the fuse with another 15A fuse. The microcomputer has been affected by electrical noise. Eject the disc or tape, then insert it again. Turn the power off and then on again. The road surface is rough. Wait for the road surface to improve before playing a disc. The unit is not mounted securely. Install the unit securely. Be sure to use the rear strap if the vehicle does not provide support for the rear of the unit. (See page 24) The disc is defective. Try another disc. If it plays properly, the first disc may be defective. The disc is dirty. Clean the disc as explained on pages 3-4. The antenna cable is not Insert the antenna cable firmly connected. into the antenna jack on the unit. The signals are weak. Select a station using manual tuning. -ā21ā-