Sanyo MCDZX500 Instruction Manual - Page 2

(0 ..* PRECAUTIONS CAUTION THIS PRODUCT CONTAINS A LOW 77- ..4'.4 0 POWER LASER DEVICE, TO EN- i 00 SURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PRODUCT. REFER ALL SERVICING TO QUALI- FIED PERSONNEL. CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT j • The apparatus shall not be exposed to dripping or splashing. • No object filled with liquids, such as vases, shall be placed on the apparatus. • Do not use where there are extremes of temperature (below 5°C or exceeding 35°C). • Because of the CD player's extremely low noise and wide dynamic range, there might be a tendency to set the volume on the amplifier unnecessarily high. Doing so may produce an excessively large output from the amplifier which could damage your speakers. • Sudden changes in the ambient temperature may cause condensation to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 1 hour, and then proceed to operate. • Do not install this equipment in a confined space, such as a book case or built in cabinet. IMPORTANT If the plug supplied with this equipment is not suitable for the socket outlets in your home it should be cut off and replaced with the correct type. Disposal of Plug If the non rewireable plug is to be cut off, the removed plug should be disposed of carefully as there is a shock hazard should the plug be inserted into a live socket. Replacing Fuse The detachable fuse cover must be replaced after changing the fuse. Only a 3A fuse should be used and should comply with BS1362 and should carry the ASTA mark T . The wires in the mains lead are coloured in accordance with the following code: Blue Neutral Brown Live The wires in the mains lead must be connected to the terminals in the plug as follows; Wire colour Plug terminal marking Blue N or Black or Blue Brown L or Red or Brown Do not connect either wire to the earth terminal. If the mains plug contains a fuse this should be 3A, if a plug without a fuse is used the distribu- tion board fuse should not be greater than 5A. - Disconnect the mains plug from the supply socket when not in use. Do not remove the back cover with mains connected. The unit is not disconnected from the mains unless it is unplugged from the AC outlet 1