Sanyo PDG-DWL100 Owner's Manual_Quick Reference Guide - Page 10

Remote Control Battery Installation 1 Open the battery compartment lid. 2 Install new batteries into the compartment. 3 Replace the compartment lid. Two AAA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in the compartment. To ensure safe operation, please observe the following precautions : ■ Use two (2) AAA type batteries. ■ Always replace batteries in sets. ■ Do not use a new battery with a used battery. ■ Avoid contact with water or liquid. ■ Do not expose the remote control to moisture or heat. ■ Do not drop the remote control. ■ If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries. ■ Risk of an explosion if battery is replaced by an incorrect type. ■ Dispose of used batteries according to the instructions. ■ If the new battery are installed into the compartment within 3~4 hours, the remote control code will not be returned to default. ■ The original setting will be kept and will not be erased. Note Remote Control Operating Range  Infrared Remote Point the remote control Receiver is provided toward the projector (In- on the top of the pro- frared Remote Receiver) jector. when pressing any button.  Point the remote Maximum operating range control from obliquely for the remote control is above frared toward the InRemote Receiver about 39.4' (12m) and 60° in when operating the top of the projector. remote control. 39.4' (12m) Approx.30° 10