Sanyo PLC-WL2503 Owners Manual - Page 9

Part Names and Functions Side Terminal ① ② ③ ④ ⑤ ⑥ ⑦ ⑩⑨ ⑧ ① LAN Connection Terminal Connect the LAN cable (refer to the owner's manual of "Network Set-up and Operation"). ② HDMI Connect the HDMI signal from computer or video equipment to this terminal (pp.14,16). is registered trademarks of HDMI Licensing, LLC. ③ COMPUTER IN 1 / COMPONENT IN Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.14,16). ④ COMPUTER IN 2/MONITOR OUT This terminal is switchable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/COMPONENT IN terminal (pp. 14, 50)]. ⑤ S-VIDEO IN Connect the S-VIDEO output signal from video equipment to this jack (p.15). ⑥ AUDIO OUT (VARIABLE) Connect an external audio amplifier to this jack (pp.14-16). This terminal outputs sound from AUDIO IN terminal (⑧ or ⑨) or HDMI terminal ② (digital audio). ⑦ CONTROL PORT When controlling the projector with RS-232C, connect the control equipment to this connector with the serial control cable. ⑧ COMPUTER / COMPONENT AUDIO IN Connect the audio output (stereo) from a computer or video equipment connected to ②, ③ or ④ to this jack (pp.14,16). ⑨ AUDIO IN Connect the audio output signal from video equipment connected to ⑤ or ⑩ to this jack. For a monaural audio signal (a single audio jack), connect it to the L (MONO) jack (p.15). ⑩ VIDEO IN Connect the composite video output signal to this jack (p.15). 9