Sanyo PLC XT35L Owners Manual - Page 64
Image is Top/Bottom reversed°, Image is Left/Right reversed°
UPC - 086483069215
View all Sanyo PLC XT35L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Appendix off and wait until condensation evaporates. - Projecting from the excessive slant angle to the screen may cause keystone distortion and partial imperfect focus. See page 18. Picture is not bright enough. - Check if "Contrast" or "Brightness" are adjusted properly See page 42. - Check if "Image level" is selected properly See page 41. - Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching. Replace the lamp with a new one promptly. See pages 59-60, 69. - Check the Lamp control function See page 49. The color is strange. - Check the Input signal, color system, video system, or computer system mode. - Adjust the Image level properly. See page 41. Image is Left/Right reversed. Image is Top/Bottom reversed. - Check the Ceiling/Rear function. See page 45. - Check the Ceiling function. See page 45. The image is distorted or runs off. - Check the "PC Adjustment" menu or "Screen" menu and adjust them. See page 37-40, 45-47. The edge of image is distorted. - With maximum lens shift, image distortion may be observed. No sound - Check the audio cable connection from audio input source. - Adjust the audio source. - Press the Volume + button. See page 29. - Press the Mute button. See page 29. - When the AUDIO OUT is plugged in, the projector's built-in speaker is not available. - Is the image projected? You will hear the sound only when the image is projected. Auto PC adjustment function does not work. - Check the Input signal. Auto PC Adjustment function can not work. when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected. See page 38. - The Auto adj. icon turns gray and cannot be operated with the digital signals. See page 38. Some displays are not seen during the operation. - Check the Display function. See page 52. The setting does not remain after - Make sure you selected "Store" after adjusting settings. Some settings turning off power. cannot be stored if not registered with "Store." Power management function does - Power management function cannot work while "Freeze" or "No Show" not work. function is running. Image disappears automatically - Check the power mamagement function in the Setting. The power management is set to "On" at the factory. 64