Sanyo PLC-XU88 User Manual - Page 68
Indicators and Projector Condition, Indicators, Appendix
View all Sanyo PLC-XU88 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Indicators and Projector Condition Check the indicators for projector condition. Indicators WARNING LAMP POWER TEMP. REPLACE red/green red yellow Projector Condition The projector is off. (The AC power cord is unplugged.) Appendix The projector is in stand-by mode. Press the POWER ON/STAND- BY button to turn on the projector. The projector is operating normally. The projector is preparing for stand-by or the projection lamp is being cooled down. The projector cannot be turned on until cooling is completed and the POWER indicator stops blinking. The projector is in the Power management mode. The temperature inside the projector is abnormally high. The projector cannot be turned on. When the projector is cooled down enough and the temperature returns to normal, the POWER indicator stops blinking and the projector can be turned on. (The WARNING indicator keeps blinking.) Check and clean the filter. The projector has been cooled down enough and the temperature returns to normal. When turning on the projector, the WARNING TEMP. indicator stops blinking. Check and clean the air filter. The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center for service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard. • • • green. • • • red • • • off • • • blinks green. • • • blinks red. When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replacement counter after replacing the lamp. See pages 60-61. 68