Sanyo PLC-ZM5000S Owners Manual - Page 73
Appendix, Troubleshooting
View all Sanyo PLC-ZM5000S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Appendix Troubleshooting Before calling your dealer or service center for assistance, check the items below once again. 1. Make sure you have properly connected the projector to peripheral equipment as described on pages 19-21. 2. Check the cable connection. Make sure that all computers, video equipment, and power cords are properly connected. 3. Make sure that all power is switched on. 4. If the projector still does not produce an image, restart your computer. 5. If an image still does not appear, disconnect the projector from your computer and check your computer monitor's display. A problem may be noticed with your graphics controller rather than with the projector. (When you reconnect the projector, be sure to turn the computer and monitor off before you turn on the projector. Turn on equipment in the order of the projector and computer.) 6. If a problem still persists, check the following solutions. Problem: Solutions No power. - Plug the power cord of the projector into the AC outlet. - W ait until the POWER indicator stops blinking to turn on the projector again. (See page 23) - C heck the WARNING TEMP. indicator. If the WARNING TEMP. indicator is blinking, the projector cannot be turned on. (See page 72) - Unlock the Key lock function for the projector. (See page 61) - S ee if the filter cartridge is inserted. (See page 67) - Check the projection lamp. (See pages 69-70) PIN code dialog box - PIN code lock is being set. Enter a PIN code; the "1234" or numbers you have set. appears at start-up. (See pages 23, 61-62) The initial display is not shown. The initial display is not same with the default one. - Make sure Off or Countdown Off is not chosen at Display function. (See "Setting" section on page 52) - Make sure User or Off is not chosen at Logo select function. (See "Setting" section on page 52) When the projector is on and you press the input button, an icon other than the Lamp mode icon appears. - That is the Filter warning icon. (See page 66) An icon other than Input mode or Lamp mode icon appears. No image. - That is the Lamp replacement icon or the Filter warning icon. (See pages 66,69) - Check the connection between your computer or video equipment and the projector. - See if the input signal is correctly output from your computer. Some laptop computers may need to be changed the setting for monitor output when connected to the projector. See your computer's instruction manual for the setting. - It takes about 30 seconds to display an image after turning on the projector. - See if the selected system is corresponding with your computer or video equipment. - Select correct input source once again through menu operation. (See pages 33-35) - Make sure the temperature is not out of Operating Temperature (41˚F-104˚F [5˚C- 40˚C]). - Make sure that the shutter is opened. (pp.27, 63) - E nd of lamp life is approaching. Replace the lamp with a new one promptly. (See page 69) appears on the screen 73