Sanyo SRR-72GD-MED Instruction Manual - Page 17

Component Identification 1. Functions of the Buttons 1. A ON/OFF Turns Window A ON or OFF. 2. B ON/OFF : Turns window B ON or OFF. 3. SELECT : Select window A or window B. And turns defrost system ON manually. 4. TEMP. SET : Temperature Selection. 5. UP : Increase Temperature. 6. DOWN : Decrease Temperature. 2. How to Set the desired temperature. 1. The window A, B digital indicator will display the actual interior temperature when the unit is turned on the first time. 2. Press the "A ON/OFF" button to start. The LED is indicated that the unit is on. 3. Press the "TEMP.SET" button. The dot light of selected window( A or B) will blink 4. Set a desired temperature within the range of application by pressing "UP" and "DOWN" Button. When "UP" and "DOWN" button is pressed, the digital read-out will change from actual temperature to setting temperature. Then press the "TEMP.SET"button one more time when you finish setting the temperature. The digital read-out will display actual interior temperature again. 5. The system will operate within 1 minutes after the above the procedures are successfully completed. 3. ALARM FUNCTION PRESET AT ±- 5°C AROUND ST POINT(non-adjustable) 4. Defrost There are two types of defrost operations in the unit, automatical and manual. The automatic defrost of freezer will automatically defrost unit thirty minutes every six hours and refrigerator will defrost every eight hours. A forced defrost could be turned on at any time by pressing "SELET"button for lminutue and then defrost signal & time "d00" will be shown on the defrost operation. The programed standard defrost time is thirty minutes. However, its status will be automatically terminated to prevent the risk of fire hazards befor the programed thirty minutes if the heater temperature reaches certain temperature. 17