Sanyo SU30 Instruction Manual, PLC-SU30 - Page 12

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cable or adapter is not supplied with this projector.) • VGA Cable (HDB 15 pin) • USB Cable ✽ • Control Cable for PS/2 Port • MAC Adapter (When connecting to Macintosh computer) ✽ • DVI-Digital Cable (for Single Link T.M.D.S.) ✽ • Audio Cables (RCA x 2 and Mini Plug (stereo) x 1) ✽ • Control Cable for Serial Port ✽, or ADB Port ✽ IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) 12 Desktop type Laptop type Monitor Output Monitor Output Audio Output USB port Serial port PS/2 port ADB port MAC Adapter ✽ Set slide switches according to the chart below. DVI Cable ✽ Audio Cable ✽ (stereo) USB Cable ✽ Control Cable for Serial Port ✽ Terminal Control Cable for PS/2 Port Terminal Control Cable for ADB Port ✽ Terminal VGA Cable COMPUTER IN DIGITAL COMPUTER AUDIO IN USB COMPUTER IN ANALOG COMPUTER IN VIDEO DIGITAL R - AUDIO IN - L (MONO) Y - Pb / Cb - Pr / Cr S - VIDEO AUDIO IN R - AUDIO OUT - L COMPUTER RESET Use one of these Control Cables corresponding with the terminal of your computer. CONTROL PORT MCI COMPUTER IN ANALOG NOTE : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on. x MAC ADAPTER (Not supplied) Set switches as shown in the table ON below depending on RESOLU- TION MODE that you want to use before you turn on projector and OFF computer. ON DIP 123456 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF USB CONTROL PORT AUDIO OUT Terminals of the Projector Audio Cable (stereo) ✽ Audio Input External Audio Equipment Audio Amplifier Audio Speaker (stereo)