Sanyo XU83 Instruction Manual, PLC-XU83 - Page 51
On start, Lamp control, Remote control, Pointer, To change the code for the projector, Finger
View all Sanyo XU83 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
On start When this function is "On", the projector will be automatically turned on just by connecting the AC power cord to a wall outlet. ✔Note: Be sure to turn the projector off properly (see "Turning Off the Projector" on page 22). If the projector is turned off in the incorrect sequence, the On start function does not operate properly. On start Lamp control This function allows you to change brightness of the screen. Normal ....normal brightness Auto ........brightness according with the input signal Eco ..........lower brightness reduces the lamp power consumption and extends the lamp life. Pointer You can emphasize a part of the projected image with this function. Choose either Spotlight or Pointer with the Point ed button and press the SELECT button. Then select one of three different sizes (Large, Middle, and Small) of Spotlight or a pointer of three different patterns (Arrow, Finger, and Dot) of Pointer. (See page 13 for operation.) Remote control This projector provides eight different remote control codes (Code 1-Code 8); the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating several equipment at the same time. The same code should set on both the projector and the remote control. For example, operating the projector in "Code 7",the remote control unit also must be switched to "Code 7". To change the code for the projector; Select a remote control code in this Setting Menu. To change the code for the remote control; While holding down the MENU button, press the IMAGE button number of times corresponding to the remote control code for the projector. (See page 14 for details.) Remote control Setting 51 Setting