Sanyo XU83 Instruction Manual, PLC-XU83 - Page 58
Lamp Replacement - plc bulb
View all Sanyo XU83 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Maintenance and Cleaning Lamp Replacement When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly. WARNING: TURN OFF THE UV LAMP BEFORE OPENING THE LAMP COVER This indicator is yellow when the life of the projection lamp draws to an end. Top Control ON - OFF POWER MENU WARNING INPUT LAMP REPLACE AUTO SET UP SELECT - VOLUME + VOLUME CAUTION Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp. 1 Turn off the projector and disconnect the AC power cord. Allow the projector to cool for at least 45 minutes. 2 Remove the screw with a screwdriver, and remove the lamp cover. 3 Remove 2 screws of the lamp with a screwdriver and pull out the lamp by grasping the handle. 4 Replace the lamp with a new one and tighten the 2 screws back into position. Make sure that the lamp is set properly. Replace the lamp cover and tighten the screw. 5 Connect the AC power cord to the projector and turn on the projector. 6 Reset the lamp replacement counter. See "Lamp Replacement Counter" on the next page . Lamp Cover Screw Handle Screw Screw Lamp ORDER REPLACEMENT LAMP Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. ● Model No. of your projector ● Replacement Lamp Type No. : PLC-XU86/ PLC-XU83 : POA-LMP90 (Service Parts No. 610 323 0726) 58