Schwinn 103 Upright Bike Assembly Manual - Page 10
Attach, Slider
View all Schwinn 103 Upright Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Assembly Stage #3 Attach Seat Post, Slider, and Pad to Main Unit 3 31 30 9 e 0 Assembly Hardware Required: (1) Seat Slider Washer (item #31) (Already attached to bike) 1. Insert SEAT POST (#29) into corresponding hole in MAIN UNIT (#20). Tighten down with SEAT POST ADJUSTMENT KNOB, (#27). 2. Insert SEAT SLIDER (#32) into top of SEAT POST (#29), Tighten with SEAT SLIDER WASHER (#31) and SEAT SLIDER KNOB (#30). 3. Insert SEAT PAD (#33) onto SEAT SLIDER (#32). Tighten bolt on underside of the seat with a wrench until seat no longer twists or tilts. 4. Seat Adjustment: Adjust the seat height by unscrewing seat post adjustment knob and tightening into appropriate adjustment hole on the seat post. Leg should be almost fully extended at the bottom of the pedal stroke. Fore and Aft seat position can be adjusted with the seat slider knob. If the seat wobbles make sure that both knobs (#27 and #30) are fully tightened. 9