Schwinn 201 Recumbent Bike Assembly Manual - Page 12
Before, proceeding, please, complete, following, steps., Failure, could, damage, handgrip, heart,
View all Schwinn 201 Recumbent Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Assembly Stage #4 Attach Seat Rail and Lower Base Frame to Main Unit ca=41 23ki, 232 1 2 2 22 10 24 STEP12 Assembly Hardware Required: (7) Allen Bolts 16 mm long (item #22) (3) Flat Washers (item #2) (2) Allen Bolts 90 mm long (item #24) (2) Curved Washers (item #19) (4) Flat Washer (item #7) Step 10: Slide the LOWER BASE FRAME (#32) into the MAIN UNIT (#31), attach with 3, 16mm BOLTS (#22) and 3 FLAT WASHERS (#2). Do not completely tighten until after step 12. - IMPORTANT Before proceeding to step 11 please complete the following steps. Failure to do so could lead to damage to the handgrip heart rate wires! 1) Remove END CAP (#11) from the end of the seat rail. The coiled wire seen above the seat rail needs to be re-routed out the back of the seat rail . 2) Pull the wire from the back of the seat rail until the male prong is flush with the front of the seat rail. Connect the cables from MAIN UNIT and Seat Rail. Tape can be used around the attachment of the two cable ends to ensure that they do not become disconnected. 3) Gently pull the excess cable from the back of the seat tube so that the cable running through the seat rail is taut. Be careful not to pull apart the cable connection you have just made. Slide the seat rail with seat assembly gently into the main unit, while pulling the cable tight from the back of the seat rail. Slide the seat rail slowly into the main unit. Using a flashlight check to make sure that the cable is not protruding from the bottom of the seat rail as it slides