Schwinn 420 Elliptical - 2010 Model Owner's Manual - Page 13
Auto Shut-Off Sleep Mode, Console Setup Mode
View all Schwinn 420 Elliptical - 2010 Model manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Auto Shut-Off (Sleep Mode) If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while in Sleep Mode. Note: The Console does not have an On/Off switch. Console Setup Mode The Console Setup Mode lets you set the units of measure to either English or Metric, adjust the contrast of the display, and stop or start the motivational messages. Motivational messages show on the screen to increase your enthusiasm and to give positive feedback while you are working out. 1. Hold down the LOCK/SCAN button and Increase button together for 3 seconds while in the POWER-UP MODE to go into the CONSOLE SETUP MODE. 2. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE. 3. Push START/ENTER to set. 4. Push the Increase/Decrease buttons to change between ENGLISH and METRIC units. 5. Push START/ENTER to set. 6. Push Increase/Decrease to adjust the screen contrast (BACKLIGHTS; "5" = maximum intensity, "1" = minimum). 7. Push START/ENTER to set. 8. The Console shows TOTAL HOURS. 9. Push START/ENTER. 10. Push Increase/Decrease to turn motivational messages off or on. 11. Push START/ENTER to set. 12. Push Increase/Decrease to set which software version to use ("SW30 V1.0" = x20 machine, "SW40 V1.0" = x40 machine, or "NLS 514" = 514 machine). 13. Push START/ENTER to set. Note: Push STOP/RESET for previous screen. 13