Schwinn 420 Elliptical - 2010 Model Owner's Manual - Page 18

Troubleshooting Problem No display / not fully displayed / unit will not turn on Check Electrical (wall) outlet The Connection at front of unit Main console cable integrity Main console cable connections / orientation Console display for cracks or other damage Display The Unit operates but Telemetric HR not Chest Strap displayed Interference The Chest Strap Console displays "E2" error code No speed / RPM reading, Console displays "E3" error code Check data cable integrity Check data cable connections/orientation Console Electronics Main Console cable integrity Main Console cable connections / position The Magnet position (requires shroud removal) RPM Sensor (requires shroud removal) Solution Use a correctly operating outlet. Connection must be secure and not damaged. Replace adapter or connection at unit if damage shows. Replace the cable if the wires are crimped or cut. Make sure the cable is connected correctly behind the Console and at the base of the Console Mast. Replace the Console if damaged. Replace the computer if the Console does not fully display. Make sure that the strap is directly against skin and contact area is moist. The Strap must be Polar® compatible. Move the unit away from sources of interference (TV, Microwave, etc). Connect the strap to a functioning Polar® compatible device to see if it works. If it does not function, replace the strap. If strap works with other devices but not with the elliptical, replace the HR receiver. All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. If tests reveal no other issues, Console should be replaced. All wires in cable must be intact. Replace the cable if the wires are crimped or cut. Make sure the cable is correctly positioned and connected. The small latch on connector must line up and click into position. Replace the Flywheel or full primary assembly if you do not see a magnet. RPM sensor must be aligned with magnet and connected to data cable. Re-align sensor if necessary. Replace if there is any damage to sensor or connecting wire. 18