Schwinn 430 Elliptical 2013 model Assembly and Owner's Manual - Page 10
Attach the Manual Lift Assembly using the Arm Pivot Rod
View all Schwinn 430 Elliptical 2013 model manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3. Attach the Manual Lift Assembly using the Arm Pivot Rod Note: H ardware is pre-installed and not on the Hardware Card. * NOTICE: With the Arm Pivot Rod under the plate junction, push the Manual Lift Assembly toward the Frame Assembly and fully tighten hardware. Remove the Arm Pivot Rod after tightening. Keep fingers away from any pinch opportunities when placing or removing the Arm Pivot Rod. 21 * * 3 10
10
3.
Attach the Manual Lift Assembly using the Arm Pivot Rod
Note:
Hardware is pre-installed and not on the Hardware Card.
*
NOTICE:
With the Arm Pivot Rod under the plate junction, push the Manual Lift Assembly toward the Frame Assembly
and fully tighten hardware. Remove the Arm Pivot Rod after tightening.
Keep fingers away from any pinch opportunities when placing or removing the Arm Pivot Rod.
*
*
21
3